FAIL (the browser should render some flash content, not this).

SPOT & STAIN TREATMENT PROCEDURES

A Apply dry cleaning fluid, use dry towel/cloth. Blot, do not rub. Repeat with dry cleaning fluid application. Blot, do not rub. Dry with weighted pad of towels.

B Scrape or blot up excess spill. Apply detergent solution (see 'Cleaning Solutions'), use damp towel. Blot, do not rub. Apply water with damp towel. Blot Dry with weighted pad of towels.

C Scrape or blot up excess spill. Apply detergent (See 'Cleaning Solutions'), use damp towel. Blot, do not rub. Apply ammonia (See 'Cleaning Solutions'), use damp towel. Blot, do not rub. Apply water with damp towel. Blot - Dry with weighted pad of towels. Apply white vinegar (undiluted), only after stain is removed.

D Scrape or blot up excess spill. Freeze with ice cubes. Shatter with blunt object such as the back of a spoon. Vacuum chips away before they melt.

E Apply nail polish remover (non-oily acetone type) - use cotton towel to apply the spill. Do not wet through to carpet backing. Pick up softened material - use clean white paper towel and push towards the centre of the spot to avoid spreading the material. Repeat above - soften and carefully remove a layer of the material each time. Haste may spread the stain and/or damage the carpet.

F Apply detergent solution (See 'Cleaning Solutions'), use damp towel, leave 3-5 minutes. Blot, do not rub. If stain is removed, finish with a water rinse, blot, followed with a pad of weighted paper towels. If stain not removed continue as follows. Apply hydrogen peroxide solution (See 'Cleaning Solutions'), let stand 2 to 3 hours under a weighted sheet of plastic wrap. Repeat application of hydrogen peroxide and dry under weighted plastic wrap until removal is complete. Apply water with damp towel. Blot - Dry with weighted pad of paper towels. Apply white vinegar (undiluted), only after stain is removed.

G Scrape of excess material. Cover with white cotton towel or brown paper. Apply warm iron until material is absorbed. Be sure towel is large enough to cover the stained area. Take care never to let the iron touch the carpet as the fibre may melt. Change towel or rotate to clean area and repeat until all area is absorbed.

H Vacuum away as much as possible. Loosen remaining material by tapping with a scrubbing brush or toothbrush. Tap with brush, do not scrub. Vacuum again.

I Scrape of excess material. Lightly rub area with a fresh slice of white bread.

CLEANING SOLUTIONS

Detergents; Mix a quarter teaspoon of clear, hand/dish washing detergent with one cup of warm - not hot - water.
Hydrogen Peroxide; Mix half cup (3% solution as sold commercially) with one teaspoon household ammonia (use within 2 hours of making).
Ammonia; Undiluted, unscented, clear household ammonia.
Dry Cleaning Fluid; Liquid, non-oily, non-caustic.

IMPORTANT - Some spillages, despite early attention, i.e. Bleach, plant foods, hot tea, hot coffee, Ribena and other cordials may result in the permanent staining of the carpet.